UNIVERSAL PRODUCTS SM0105 Manuel D’Utilisation

Page de 2
Please thoroughly read this user’s manual and follow the operating 
instructions here under. 
 
To replace batteries,please refer to the following functions. 
 
(1)  Battery installation 
1)  Unscrew the two screws on the back ,take off the rear cabinet 
2)  Take out the circuit board 
3)  Place the batteries in the battery holder with the “+” side upward 
4)  Make the side of batteries closely stick to inner wall of battery 
holder,then put the circuit board in the cabinet 
5)  Cover the back cabinet,fasten the two screws 
 
(2)  Battery test 
 Push the switch to “on”position,the red indicatior blinks.When the 
indicator  becomes  dim,it  indicates  low  power,need  to  replace  the 
batteries. 
 
(3)  On battery replacement 
(Regularly check the working condition this Electronics Personal Remind 
Alarm,check whether the power of batteries is sufficient) 
Recommenter batteries: 3V CR2032  
 
In following cases,replace the batteries 
When low signal or the red indicator does not blink then replace the 
batteries  
 
(4)  Precautions 
1)  DO not use this product on airplane. 
2)  If you have used it for a long time ,please take out the batteries 
and place it in cold and dry places so as to prolong the life of 
batteries. 
3)  Generally,sending wave of the product is less than 1mW,which will not cause 
injury to our body. 
4)  Keep the product far from water. 
5)  Please  wear  the  transmitter  well  in  the  objects  to  be 
protected,because  once  the  transmitter  is  separate  from  the 
objects,the distance may be farther than the preset safe distance. 
6)  The product has wide applications,but the children below 3 years 
should not use it unless custody of adults. 
7)  Any fault of this product caused by dropping,collision by users will 
be excluded from the scope of free warranty. 
(5)  Specification 
Safe distance     0-25m (if there are no special wireless blocking)