Onset Computer Corporation RECEIVER Manuel D’Utilisation
HOBOnode
®
System Quick Start Guide
Follow the steps in this Quick Start Guide to setup a HOBOnode system.
Part# MAN_HOBOnode-QS Document # 12537-A
Step 2 -
Activate Devices
You must push the Activate button on HOBONodes and Repeaters to enable
them. Remove the cap and locate the brown button. Hold it down for 2
seconds. The LEDs will flash briefly to indicate that the device is activated.
them. Remove the cap and locate the brown button. Hold it down for 2
seconds. The LEDs will flash briefly to indicate that the device is activated.
Topology
Components
The HOBOnode System includes:
- 1 HOBOnode Receiver
- HOBOnode(s)
- HOBOnode Repeater(s) (Optional)
- 1 HOBOnode Receiver
- HOBOnode(s)
- HOBOnode Repeater(s) (Optional)
Activating HOBONodes
Activating Repeaters
The following diagrams show two basic topologies.
Step 1 -
Connect HOBOnode Receiver
Connect the receiver to the base PC. Put
the receiver into the base and mount
vertically or lay horizontally on a desk.
Make sure the antenna is pointing upward.
the receiver into the base and mount
vertically or lay horizontally on a desk.
Make sure the antenna is pointing upward.