Alltek Marine Electronics Corporation AR150WS Manuel D’Utilisation
II
WARNING
The equipment said in this manual must only be used to which it was designed. Improper
operation or installation may cause damages to the equipment or personal injury. AMEC
will not incur any liability of equipment damage or personal injury due to improper use or
installation of the equipment. It is strongly recommended to read this manual and the
following safety instructions before proceeding to installation or operation.
SAFETY INSTRUCTIONS
ELECTRICAL SHOCK HAZARD
Do not disassemble equipment.
Only qualified personnel could
work inside the equipment.
Improper disassemble or
modification could cause
electrical shocks, fire, or personal
injury.
Only qualified personnel could
work inside the equipment.
Improper disassemble or
modification could cause
electrical shocks, fire, or personal
injury.
WARNING
WARNING
TURN OFF THE POWER IMMEDIATELY
IF WATER LEAKS INTO THE
EQUIPMENT OR OBJECT DROPS INTO
THE EQUIPMENT.
Continue operating the equipment could
cause electrical shock or fire. Contact your
nearest distributor for service.
IF WATER LEAKS INTO THE
EQUIPMENT OR OBJECT DROPS INTO
THE EQUIPMENT.
Continue operating the equipment could
cause electrical shock or fire. Contact your
nearest distributor for service.
TURN OFF THE POWER BEFORE
PROCEEDING WITH INSTALLATION.
Proceeding with installation with the
power on could cause electrical shock
or fire.
PROCEEDING WITH INSTALLATION.
Proceeding with installation with the
power on could cause electrical shock
or fire.
EVEN THOUGH THE EQUIPMENT IS
WATERPROOF, PLEASE AVOID
DIRECT CONTACT WITH RAIN OR
SPLASHING WATER.
Electrical shock or fire could be resulted
if water leaks into the equipment.
WATERPROOF, PLEASE AVOID
DIRECT CONTACT WITH RAIN OR
SPLASHING WATER.
Electrical shock or fire could be resulted
if water leaks into the equipment.
AVOID OPERATING THE EQUIPMENT
WITH WET HANDS.
Electrical shocks could be resulted if
operating with wet hands.
PLEASE USE THE PROPER FUSE.
Damage to the equipment or fire could be
resulted if using the wrong fuse.
WITH WET HANDS.
Electrical shocks could be resulted if
operating with wet hands.
PLEASE USE THE PROPER FUSE.
Damage to the equipment or fire could be
resulted if using the wrong fuse.
Warning Label
A warning label (Figure 2-1-1) is
attached underneath the equipment.
Warranty of the equipment will be invalid
if this label is detached or broken.
AMEC and your local agent/dealer will
not bare any responsibility of any
damage to the equipment, or damage in
related to the equipment, personnel
injury, and etc. Reject the equipment if
this label is detached or broken. Please
contact your local agent/dealer if this
label is missing.
A warning label (Figure 2-1-1) is
attached underneath the equipment.
Warranty of the equipment will be invalid
if this label is detached or broken.
AMEC and your local agent/dealer will
not bare any responsibility of any
damage to the equipment, or damage in
related to the equipment, personnel
injury, and etc. Reject the equipment if
this label is detached or broken. Please
contact your local agent/dealer if this
label is missing.
WARNING
Name: Warning Label
No Warranty if this label
is detached or broken.
保固撕毁无效
Warning
注意
MAKE SURE THE POWER SOURCE
AND THE POWER INPUT OF THE
EQUIPMENT ARE COMPATIBLE.
Damage to the equipment and fire could
be resulted if the power sources are not
correct. Please check the correct power
input on the adaptor.
AND THE POWER INPUT OF THE
EQUIPMENT ARE COMPATIBLE.
Damage to the equipment and fire could
be resulted if the power sources are not
correct. Please check the correct power
input on the adaptor.