Selex ES SPA F567DHDE-HP Manuel D’Utilisation
SELEX Communications
Information contained in this document may not be used, applied or reproduced for any purpose unless agreed
by SELEX Communications S.p.A. in writing
45
July 2010
• voted signal;
• Selection and management of Audio Frequency (AF) signals for test purposes;
• Lock / unlock of voice in local speaker (radio squelch or criterions);
• Speaker volume setting;
• Display brightness setting;
• Menu language setting;
The MMI is composed by a 8 characters display (each character is 5 x 7 pixels) and a Keypad
The keypad is composed by 16 buttons: SQ (Squelch), Fn (Function), +, -,
↵
, C (cancel) and 0 ÷ 9. In
the following a brief summary of their use is given.
SQ
Use it to open/close the analog squelch of the device
Fn
Use it to switch between stand-by mode and menu mode.
+ / -
These are multi-function buttons: they are used for navigation in menu, to up and down
speaker volume and display brightness.
↵
in menu mode use it to confirm the choice.
C
In menu mode use it to go back to previous menu.
0 ÷ 9
In menu mode use them to insert the value of parameters where required
The menu tree is described in the following table.
Menu level
1 2 3 4 5
1. Freq.RX
1. View Freq.
RTX
2. Freq.TX
1. Low
1. Low
1. Radio
2. RF Power
PA
2. Hi
1. Brightn.
Italiano
1. Settings
2. Display
2. Language
English
RTX
1. L1
2. L2
3. L3
LIF
4. L4
1. L1
2. L2
3. L3
DIF
4. L4
1. RRXa
RRX
2. RRXb
2. Spk/Lstn
CORE
3. Commands
1. Inhibit
RTX
1. RX
ON