Technologies Humanware Inc. APBT320 Manuel D’Utilisation

6-141 

 

There are two printer test documents that may be used to check the printer set-up, in a similar way 
to the embosser. You may require sighted assistance to check the results of this test. 

Print the first document, called 

"Printer Test A." Check the top line, which consists of the 

repeated sequence of the digits 

1 through 9 and zero. Use the number of full repeats and the final 

digit to determine the number of printable columns across the width of the page. If a number of 
digits are missing at the start of the line, set the Page Offset to this number and run 
"Printer Test A" again to determine the printable page width. 

Print the second test document, called 

"Printer Test B," and count the number of lines that can be 

printed on a page. 

Return to the Printer Set-up list, and set the Paper Length and Paper Width to the values determined 
in the tests. This completes the tests. You should not need to change the settings in the Printer Setup 
List, or carry out the printer test again, unless a different type of printer or paper is used. 

 

End of Embossing and Printing Documents Chapter.