Telensa Ltd. 2N4D Manuel D’Utilisation
Telecell Installation Manual
Commissioning
TL-006175-PR Issue 5 © Telensa Ltd 2018
Page 21
3
Commissioning
3.1
Commission a Telecell
The System Administrator should complete this commissioning phase.
When installing, the only available confidence check for an installer is the Power On / DIM
/ Off test.
/ Off test.
To functionally check each unit fully, the Telecell must be connected to the system,
assigned an Asset ID and the correct lamp type and Control, Monitoring and Alarm
programs set.
assigned an Asset ID and the correct lamp type and Control, Monitoring and Alarm
programs set.
Telecells are loaded onto each system when dispatched. To confirm the Telecell OSID is
loaded, filter on the Telecells page within the UI.
loaded, filter on the Telecells page within the UI.
3.2
Set Up a Telecell
The Telecell(s) must be connected prior to the commissioning phase. In areas with poor
coverage, it may be necessary to set up Relays (ROS – Relay Outstation).
coverage, it may be necessary to set up Relays (ROS – Relay Outstation).
3.3
Configuration
Once the asset has been imported, use the following steps to ensure the Asset returns
data and operates as expected.
data and operates as expected.
3.3.1
Set Telecell to Asset
1)
Go to Edit Assets Configuration > Gateway > Assets > Asset Details: