Essence Security International ltd. ES7000EG Manuel D’Utilisation
Operation
30
EverGuard Control Panel
3.2.12
Maintenance
A singe Maintenance LED provides the system status when the ES7000EG control
panel is set to Maintenance mode. When the communications mini USB connecter
is attached or detached, an audible beep is sounded.
panel is set to Maintenance mode. When the communications mini USB connecter
is attached or detached, an audible beep is sounded.
Table 14: Maintenance Related Indicators
Attach Indication/
During Installation
During Installation
Yellow - open
zone
Yellow- call
guard
Attach
beep
beep
After attachment,
connection is
identified
connection is
identified
Fault Attached State
Yellow
Bad beep
After plug-in failure
End Install Performed
Yellow
After successful
installation
installation
Detached Without
Preceding “End
Install”
Preceding “End
Install”
Off
Detached
beep
beep
After detach, without
performing “end
install”
performing “end
install”
Detached preceding
“End Install”
“End Install”
Off
“End install”
preceding time-out
preceding time-out
3.2.13
No Default
The LED combination in the table below indicates a non-operational mode in
which the panel is not in operational mode or is missing default parameters.
which the panel is not in operational mode or is missing default parameters.
Table 15: Non-operational mode indicators
No Defaults
Indication
Indication
Red - fault
Yellow - open zone
No defaults beep While no default
parameters were
downloaded
downloaded