Phonetone Technology Co. Ltd. PTE2010 Manuel D’Utilisation
The input voltage for the Amplifier is 6V DC. DO NOT use this Amplifier with a
regular 12V power supply. If a 12-volt power supply is connected directly to this
Amplifier, it will be damaged and the user may also be injured.
(Optional) Mounting the Amplifier with Velcro:
You can leave the Amplifier on top of a flat surface or use the enclosed Velcro straps to
mount the Amplifier. There are two 6cm x 2.5cm Velcro strips (hook-and-loop pairs) in
the box for mounting the amplifier.
Determine the location where your Amplifier will be placed. Clean the intended surface
and allow it to dry. Peel the protective paper from the back of the hook sides of the
Velcro. Press the adhesive side of the Velcro strips into place on the bottom of the
Amplifier, one strip on each end. Wait 5 minutes for the adhesive to set before
attaching the loop side of the Velcro to the hook side. The adhesive bond will reach its
maximum strength after 24 hours.
With both of the Velcro loop and hook pieces attached to the back of the Amplifier, peel
the protective paper off of the back of the loop strips. Press the entire Amplifier into its
mounting place. Wait 5 minutes for the adhesive to set. Make sure the Amplifier is
firmly seated. To remove the Amplifier, rotate it across the Velcro – do not pull the
Amplifier or cables.
(
Optional) Using Other External Antennas:
It is possible to connect this Amplifier to an external antenna that is not supplied in this
package. If the user wishes to do that, it may be necessary to use the included Adapter
to couple that antenna to the Amplifier. This Adapter connects to the antenna input side
of the Amplifier with an SMA-type male connection. The other side of the Adapter is an
FME-type male or N-type female connector, which may be used to connect with other
antennas that use the FME or N type of physical connector.
STARTING THE AMPLFIER
The signal is received by the outside antenna from the cell tower, then amplified and
transmitted to your phone through the inside antenna. When the phone transmits, the
signal is received by the inside antenna, then amplified and transmitted to the cell tower
through the outside antenna.
Now you are ready to make and receive cell phone calls with powerful signal
amplification! Note that it is normal for the Amplifier’s case to be warm during
operation.
4 / 6