Cisco 7513 AC PWR-7513-ACE= Manuel D’Utilisation
Codes de produits
PWR-7513-ACE=
1200-Watt AC-Input Power Supply Replacement Instructions 15
Checking the Installation
•
If the OUTPUT FAIL LED lights on two supplies that are connected to separate AC
sources, assume that an overvoltage or overtemperature condition is causing the power
supplies to shut down.
sources, assume that an overvoltage or overtemperature condition is causing the power
supplies to shut down.
If the power supply fails to operate properly after several attempts to initialize it, contact a service
representative for assistance. If the power supply fails (and you need to order a replacement) and you
did not record the type of power supply in your chassis, you must check the chassis in order to make
this determination.
representative for assistance. If the power supply fails (and you need to order a replacement) and you
did not record the type of power supply in your chassis, you must check the chassis in order to make
this determination.
Timesaver
The system can identify which type of power supplies are in your chassis: DC-input or
AC-input. As a general precaution, use the show environment all command and note the type of power
supply indicated in each of your chassis (indicated as either 1200W DC or 1200W AC). Record and save this
information in a secure place.
supply indicated in each of your chassis (indicated as either 1200W DC or 1200W AC). Record and save this
information in a secure place.
This completes the power supply installation. Refer to the Cisco 7500 Series Installation and
Configuration Guide for installation troubleshooting procedures, and to the Router Products
Command Reference publication for descriptions and examples of software features and commands.
Configuration Guide for installation troubleshooting procedures, and to the Router Products
Command Reference publication for descriptions and examples of software features and commands.