Zonoff Inc. EMBY001 Manuel D’Utilisation

4.  Press and release the S-Setup button.

5.  When the Device Editor window appears in the Device Configurator, TaHomA has found the channel. Rename the

channel to match the RTS device and assign it to a room. In the Device Editor window, click the existing icon to reveal 
the list of all icons available. Only one icon per channel can be selected.

NOTE: To exclude channels from TaHomA at this point, refer to Step 1b under “Excluding Z-Wave Channels from TaHomA” 
and follow the steps for exclusion.

6.  Once all Z-Wave channels have been included, press and hold the S-Setup button until the S-LED illuminates green. 

Setup is now complete, and the ZRTSI is now ready for the End User. 

NOTE: To exclude channels from TaHomA at this point, refer to Step 1a under “Excluding Z-Wave Channels from TaHomA” and 
then skip to Step 2.

1.  Make sure the S-LED is Blinking Yellow.

 1a. 

If the S-LED is Green: Unplug the ZRTSI from the outlet. Press and hold the S-Setup button while    

 

 

 

plugging the ZRTSI back into the outlet until the S-LED remains solid yellow, then release. Press and hold    

 

 

the S-Setup button again until the S-LED blinks yellow, then release. 

 1b. 

If the S-LED is Solid Yellow: Press and hold the S-Setup button until the S-LED blinks yellow, then release. 

2.  Select the channel on the Node/Channel Rotary Selector that you want to exclude from TaHomA.

3.  In TaHomA’s Device Configurator, click the “Remove Device” button in the upper right hand corner of the screen.

4.  Press and release the S-Setup button. TaHomA will remove the channel and the icon will disappear from the Device 

Configurator.

NOTE: To include channels again, refer to Step 1b of “Including Z-Wave Channels to TaHomA” and follow the steps for 
inclusion. 

Z-Wave

®

 to RTS Interface ZRTSI 

cont’d

1.  Make sure the S-LED is Solid Yellow.

 1a. 

If the S-LED is Green: Unplug the ZRTSI from the outlet. Press and hold the S-Setup button while plugging   

 

 

the ZRTSI back into the outlet until the S-LED remains solid yellow, then release. 

 1b. 

If the S-LED is Blinking Yellow: Unplug the ZRTSI. Press and hold the S-Setup button while plugging the ZRTSI into  

 

 

an outlet until the S-LED remains solid yellow, then release.

2.  In TaHomA’s Device Configurator, click the “Remove Device” button in the upper right hand corner of the screen.

3.  Press and release the Z-Setup button. TaHomA will remove the ZRTSI and the icon will disappear from the Device 

Configurator.

1.  Press and hold the Z-Setup button while plugging the ZRTSI into an outlet until the Z-LED goes out. 

2.  You are now ready to begin RTS Programming.

Z-Wave

®

 to RTS Interface ZRTSI 

cont’d