TCL Technoly Electronics Co. Ltd. SB000014 Manuel D’Utilisation
11
GB
HT-CT180
4-559-026-11(1)
F:\HT-CZ1-11_UC\4559026111\4559026111HTCT180UC\01GB-
HTCT180UC\060OTH.fm
HTCT180UC\060OTH.fm
masterpage:
Right
O
the
r Funct
r Funct
ions
Enabling the Secure Link
function
function
You can specify the wireless connection
to link the Bar Speaker to the subwoofer
using the Secure Link function. This
function can help prevent interference if
you use multiple wireless products or
your neighbors use wireless products.
to link the Bar Speaker to the subwoofer
using the Secure Link function. This
function can help prevent interference if
you use multiple wireless products or
your neighbors use wireless products.
1
Press LINK on the rear of the
subwoofer with a pointed object,
such as a pen.
subwoofer with a pointed object,
such as a pen.
You will hear beeps from the
subwoofer.
subwoofer.
2
Hold down
PAIRING on the Bar
Speaker for 5 seconds, then VOL–
for 5 seconds.
The OPTICAL and ANALOG
indicators flash alternately.
When the Bar Speaker is linked to
the subwoofer, the indicators stop
flashing.
If it failed, the indicators light up for
5 seconds. Try again the above
operation.
for 5 seconds.
The OPTICAL and ANALOG
indicators flash alternately.
When the Bar Speaker is linked to
the subwoofer, the indicators stop
flashing.
If it failed, the indicators light up for
5 seconds. Try again the above
operation.
Mounting the Bar
Speaker on a wall
Speaker on a wall
You can mount the Bar Speaker on a
wall.
wall.
• Prepare screws (not supplied) that are
suitable for the wall material and
strength. As a plasterboard wall is
especially fragile, attach the screws
securely to two studs in the wall beam.
Install the Bar Speaker horizontally, hung
by screws in studs in a continuous flat
section of the wall.
strength. As a plasterboard wall is
especially fragile, attach the screws
securely to two studs in the wall beam.
Install the Bar Speaker horizontally, hung
by screws in studs in a continuous flat
section of the wall.
• Be sure to subcontract the installation to
Sony dealers or licensed contractors and
pay special attention to safety during the
installation.
pay special attention to safety during the
installation.
• Sony shall not be held responsible for
accidents or damage caused by improper
installation, insufficient wall strength,
improper screw installation or natural
calamity, etc.
installation, insufficient wall strength,
improper screw installation or natural
calamity, etc.
1
Prepare screws (not supplied) that
are suitable for the holes on the
rear of the Bar Speaker.
are suitable for the holes on the
rear of the Bar Speaker.
Other Functions
Notes
4 mm
More than 30 mm
4.6 mm
Hole on the rear of the Bar Speaker
4.6 mm
010COV.book Page 11 Thursday, September 18, 2014 5:01 PM