Viagrow Fertilizers Inc. BINBUDDYVF1 Manuel D’Utilisation

Users Manual

To mount the spout, drill two 3/32 holes half way around, from the front center

of the steel spout on the auger (front implies the intake end of the auger).  From
the inside of the steel spout tack weld two 3/8” lock nuts (supplied).  Place the

spout over the steel auger spout and insert the shoulder bolts with the flat
washer on the outside of the spout.  Tighten until the bolts bottom out, this will
allow the spout to pivot.  Make sure that the tab of the spout is hanging towards

the intake end of the auger.

To mount the sensor, use the two holes drilled into the tab at the bottom of the
spout.  First insert the pan head screw from the outside of the spout, install one

clamp and then the other.  Insert the ¼” nuts into the inside clamp and begin to
thread the pan head screws.  Once the clamps are fastened to the spout and
slightly tightened up, insert the sensor between the clamps and finish tightening

the clamps. DO NOT OVERTIGHTEN THE PAN HEAD SCREWS!!

To install the receiver Unit, make sure that the top pin on the 7 pin round
connector is the ground (-) and the bottom is (+).  Simply insert the sensor into

the 7 pin round connector, located on the tractor.

To insert or remove batteries, simply unscrew the antenna and push slightly

down on the antenna connection while pulling on the other end of the sensor.
Insert the batteries ensuring the polarity of the batteries.  Reinsert the board
into the tube and attach the antenna.  DO NOT OVERTIGHTEN THE ANTENNA,
AS IT WILL DAMAGE THE CONNECTION!!