SparkLAN Communications Inc. 0685R04070 Manuel D’Utilisation
Setting Up a Wireless Network
for the M-Turbo® or S Series™ Ultrasound System
for the M-Turbo® or S Series™ Ultrasound System
Introduction
To archive wirelessly from the M‐Turbo® or S Series™ ultrasound system, SonoSite supports the network setup
described in this document. Use the setup instructions from the router manufacturer for general information only.
described in this document. Use the setup instructions from the router manufacturer for general information only.
After connecting the ultrasound system, you need to configure a location through the Connectivity setup page on
the ultrasound system and to connect the wireless USB dongle. For instructions to configure a location, see one of
the following:
the ultrasound system and to connect the wireless USB dongle. For instructions to configure a location, see one of
the following:
• DICOM for M‐Turbo or S Series Ultrasound System User Guide
• SiteLink
™ Image Manager 4.1.0 User Guide and Supplement P08168‐01
For more information about the ultrasound system, see the ultrasound system user guide.
Additional copies of these documents are available on SonoSite’s Web site at www.sonosite.com.
System and hardware requirements
• M‐Turbo or S Series ultrasound system (1.2 or later)
• SparkLAN Wireless 802.11g USB Dongle
Additional hardware requirements for SiteLink
™ Image Manager:
• LinkSys WRT54GS Wireless‐G Broadband Router
• Web browser on the PC (for example, Internet Explorer)
Connecting the ultrasound system
To archive wirelessly, you can connect the ultrasound system in one of two ways:
• To an existing wireless network
• To the router, which is connected to the PC
WARNING:
The wireless USB dongle is a radio transmitter designed for use as a
mobile device as defined by the Federal Communications Commission
(FCC). Do not place the transmitter on a patient’s or user’s body. Ensure
that the transmitter is located at least 20 cm (8 in) from a patient’s or
user’s body. Locating the transmitter closer than 20 cm (8 in) to a
person’s body voids the user’s FCC authority to operate the equipment.
mobile device as defined by the Federal Communications Commission
(FCC). Do not place the transmitter on a patient’s or user’s body. Ensure
that the transmitter is located at least 20 cm (8 in) from a patient’s or
user’s body. Locating the transmitter closer than 20 cm (8 in) to a
person’s body voids the user’s FCC authority to operate the equipment.
Caution:
Operating the wireless USB dongle without a regulatory label or the
correct country stamp is illegal. See the documentation from the
manufacturer of the wireless USB dongle.
correct country stamp is illegal. See the documentation from the
manufacturer of the wireless USB dongle.
To avoid damage to the wireless USB dongle when using the MDSm or
MDS Lite II, remove or insert the USB dongle only when the system is in
the stand.
MDS Lite II, remove or insert the USB dongle only when the system is in
the stand.
For environmental operating and storage specifications, see the
operating instructions from the router manufacturer.
operating instructions from the router manufacturer.