Manualsbrain.com
  1. Manuels
  2. Marques
  3. Sena Technologies Inc.
  4. PARANISD1100
  5. Manuel D’Utilisation

Sena Technologies Inc. PARANISD1100 Manuel D’Utilisation

Télécharger
Page de 48
 37
Purpose 
Set authentication and data encryption 
Parameters 
Authentication
=0: Inactivate (Default) 
Authentication
=1: Activate 
Encryption
=0: Inactivate (Default) 
Encryption
=1: Activate 
Description 
If the authentication is activated, the pin code must be set by AT+BTKEY command. Data 
encryption cannot be used when authentication is not enabled, i.e. Authentication=0 and 
Encryption
=1 will not work properly. 
 
A.3.28. AT+BTNAME=$string
 
 
Response 
OK 
Purpose 
Change device name 
Parameters 
$string
= New device name (Default=”PSDv2.0.0-445566”) 
Description 
Parani-SD can have a user friendly name for easy identification. The name allows up to 30 
alpha-numeric characters. 
Example 
AT+BTNAME=”My-Parani-SD” 
 
A.3.29. AT+BTLPM,n
 
 
Response 
OK 
Purpose 
Set low power mode 
Parameters 
n=0: Inactivate (Default) 
n=1: Activate 
Description 
During no data transmission, Parani-SD can be in low power mode to save the power. It 
takes a few seconds to wake the Parani-SD out of low power mode. 
 
A.3.30. AT+BTRSSI,n
 (Single Connection Mode Only) 
 
Response 
OK 
0,255,0,0 (repeatedly) 
Purpose 
Test signal strength 
Parameters 
n=0: Stop signal strength test 
n=1: Start signal strength test 
Description 
When Bluetooth connection is established, you can use this command in Standby status. 
The signal strength will be displayed repeatedly in order of Status, LinkQuality, Status, 
RSSI. If the LinkQuality is close to 255 and RSSI is close to 0, the signal strength is in good 
standing. 
Example 
+++ 
AT+BTRSSI,1 
OK 
0,255,0,0 
 
A.3.31. AT&V
 
 
Response 
S0:m0;S1:m1;  …Sn:mn 
OK 
Purpose 
Display all the S-registers