Therm-Omega-Tech Inc. 94030 Manuel D’Utilisation
to compensate for droop error. For clarification of this feature see the definition of terms
section at the end of this manual.
section at the end of this manual.
O F F S E T
1 0
D E G
7.4.Ramp Offset Screen
Using the up and down keys the advanced user can adjust the Ramp Offset from 10-60
deg F. The default value is 30 deg F. This offset is used as follows: When the controller
is in ramp mode the internal pit setpoint will be ramped down from the pit setpoint to the
meat setpoint + Ramp Offset. For clarification of this feature see the definition of terms
section at the end of this manual.
deg F. The default value is 30 deg F. This offset is used as follows: When the controller
is in ramp mode the internal pit setpoint will be ramped down from the pit setpoint to the
meat setpoint + Ramp Offset. For clarification of this feature see the definition of terms
section at the end of this manual.
R M
P F F S E T
3 0
D E G
7.5.Deviation Alarm Screen
Using the up and down keys the advanced user can adjust the deviation alarm from 20 to
80 deg F. The default value is 50 deg F (50° above or below set temperature). The low
deviation alarm is suppressed on startup, and will sound when the pit temperature is
above or below the pit setpoint by this amount.
80 deg F. The default value is 50 deg F (50° above or below set temperature). The low
deviation alarm is suppressed on startup, and will sound when the pit temperature is
above or below the pit setpoint by this amount.
A L A R M D E V
5 0
5 0
D E G
7.6.Cycle Time Screen
Using the up and down keys the advanced user can adjust the cycle time from 4 to 10
seconds. The default value is 6 seconds. For clarification of this feature see the
definition of terms section at the end of this manual.
seconds. The default value is 6 seconds. For clarification of this feature see the
definition of terms section at the end of this manual.
C Y C
T I M E
6
S
E C
7.7.Temperature Units Screen
Using the up and down keys the advanced user can set the temperature units to F or C.
Default setting is F. This affects all temperature displays and settings.
Default setting is F. This affects all temperature displays and settings.
T E M P U N I T
F
D E G
7.8.Reset All Screen
Using the up keys the advanced user or technician can restore the factory defaults to all
values programmed in the unit, including calibration.
values programmed in the unit, including calibration.
R E S E T A L L
When the up key is pressed the display will show:
R E S E T A L L