Radio Engineering Industries Inc. HD5-600 Manuel D’Utilisation

Page de 10
                                       
                                                   
                                                                                                       756        
9
- 10
of the task table.   
7)  How to install the WIFI antenna?   
The antenna must be installed on unobstructed place of the roof, and be fixed with glue. 
8)  The device cannot be shut down when in ignition ON/OFF mode.   
Check if the ACC signal wiring is correct and if there is voltage for ACC signal line after the key is         
turned off .   
If you have set timing recording, and at the current time it is still in task recording, the device may be   
impossible to be shut down.   
9) GPS 
anomaly. 
 
Check if the GPS antenna is properly installed. There is silkscreen GPS identification on the GPS   
antenna pedestal on the back of the MDVR device. Check if the antenna connector is blocked and   
make sure the antenna connector not be covered by other things.   
Trees block, being inside the tunnel, driving near tall buildings or viaduct, thunderstorms and other   
environmental effects may also cause to receive no GPS signal or error signal. 
10)  No voice in video files.   
See if there is an external microphone, or if the camera cannot capture audio;   
Enter into the video channel settings, then check if the audio is open;   
Ensure video input and normal recording, on which the audio recording channels must be based. 
   
11)  The device doesn’t record.   
Make sure the storage part is installed and of fine contact, the data can be read on PC, and the   
storage device is not formatted.   
Check if there are video signal input to the main device, and whether there are video images in the   
channel pictures.     
12)  Why has the MDVR device always been in a state of restart?   
Check whether the MDVR device voltage is insufficient. If the device voltage does not reach the   
start voltage, the device will restart.   
Hard disk or SD card may cause the MDVR device unable to start. You need to remove the storage   
device and then boot up to verify whether it is caused by the storage device.   
13)  Why the MDVR device cannot start?   
Check the device input power to see if the power wiring is correct, if there is ground wire connected   
back to the battery, and if the fuse of the power wire is n good condition;   
Check whether there is voltage(more than 7V) on power input ACC signal wire;   
Check whether the hard disk key is turned off.   
14)  What is the log in user name and password for new device?   
The default user name and password are both “admin”. The device password can be set as empty.   
15)    In the ON/OFF of basic settings, the low voltage protection is 8V, why?   
After testing, when the battery is lower than 8V, the voltage will lower down quickly. Therefore the   
lowest voltage is set to be 8V. When it is lower than 8V, the MDVR device will recognize it as   
external power-off and then enter into shutdown state.