YEALINK NETWORK TECHNOLOGY CO. LTD. T40P Manuel D’Utilisation

Accessing the web user interface:

Account Settings:

  Click on Account->Register->Account X (X=1,2,3)

Parameters of the account:

Network Settings:

Account Settings:

Configuring via phone user interface

Configuring via web user interface

Register status icons on the LCD screen:

1. Press the OK key when the phone is idle to obtain the IP address of the phone. 

You can configure the network settings in the following ways:

It shows the register status of the current account.

You can select Enabled/Disabled to enable/disable the account.
It is shown on the LCD screen to identify the account.
It is shown as Caller ID when placing a call.
It is an authenticated ID for authentication provided by ITSP (required).
It is provided by ITSP for registration (required).

It is provided by ITSP for registration (required).
It is provided by ITSP for registration (required).

DHCP: By default, the phone attempts to contact a DHCP server in your network to obtain its valid network settings, 
       

Static IP Address: If your phone can not contact a DHCP server for any reason, you need to configure the IP address, 
                    subnet mask, gateway address, primary DNS address and secondary DNS address for the phone 
                    manually.
PPPoE: If you are using an xDSL modem, you can connect your phone to the Internet via PPPoE mode. Contact the     
         ITSP for the PPPoE user name and password.

Press the Menu soft key when the phone is idle, select Settings->Advanced Settings (default password: admin)->Network->
WAN Port/VLAN/Webserver Type/802.1x Settings/VPN/LLDP/CDP/NAT to configure the network.

Press the Menu soft key when the phone is idle,  select Settings->Advanced Settings (default password: admin)->Accounts to 
configure the account. 

2. Open a web browser on your computer, enter the IP address into the address bar (e.g., "http://192.168.0.10" 
    or "192.168.0.10"), and then press Enter.

Register Status:            
Line Active:            
Label:                          
Display Name: 
Register Name:
User Name: 
Password: 
Server Host: 

3. Enter the user name (default: admin) and password (default: admin) in the login page and click Confirm.

Network Settings:

  Click on Network->Basic->IPv4 Config

Registered

Register Failed

Registering

3

Configuring Your Phone

Note:

 

Check with your system administrator if any error appears during the registration process or a specific 

          configuration is required for your registration.

Note:

 

For more information on account parameters, refer to Configuring via web user interface.

e.g., IP address, subnet mask, gateway address and DNS address.

Note:

 

The IP phone also supports IPv6, but IPv6 is disabled by default.

         Wrong network settings may result in the inaccessibility of your phone and may have an impact on the network 
         performance. Contact your system administrator for more information.