Texa S.p.A. NW10 Manuel D’Utilisation
4 Use with IDC3 software on AXONE 3 Mobile
No special software is required to use NAVIGATOR Wireless in combination
with the Axone 3 Mobile displaying and processing unit: everything you need
is preinstalled. You do however need to configure the communication mode
between NAVIGATOR Wireless and AXONE 3 Mobile. Follow the instructions
provided by the Texa tools configuration wizard which starts automatically
when the IDC3 program is started for the first time.
Refer to the SERVICE MENU chapter in the IDC3 instruction manual for more
details on this topic.
5 Using IDC3 software on a PC
The IDC3 software must be installed on the PC to use NAVIGATOR Wireless.
Use the DVD provided.
Insert the DVD in the PC drive. The setup program will start automatically (if
this does not happen because autorun is not configured on your PC, select
the DVD drive and double-click on the SETUP icon). Follow the instructions
which appear on the screen during setup. A new icon will be created on the
desktop at the end of the setup procedure.
this does not happen because autorun is not configured on your PC, select
the DVD drive and double-click on the SETUP icon). Follow the instructions
which appear on the screen during setup. A new icon will be created on the
desktop at the end of the setup procedure.
IMPORTANT
Insert the hardware key (USB port) for enabling the program after installation.
The hardware key must always be inserted in the display PC where the
IDC3 program is installed.
The software runs under Win2000 and WinXp operating systems.
Follow the setup wizard for Texa tools automatically started when the IDC3
software is started for the first time to configure the communication between
instrument and PC.
Refer to the SERVICE MENU chapter in the IDC3 instruction manual for more
details on this topic.
MT_NAVIGATOR Wireless_eng_00 Texa S.p.A. 52/122