Roku R1000 Manuel D’Utilisation
12/12/2005
sb_radio_draft_jmc
52
4. Write down the Key 1 value. In this example, 49774B692D is the key value. You
will enter this value into SoundBridge’s wireless setup’s Password field.
You now have the information necessary to configure your Soundbridge Radio to
connect to your network.
connect to your network.
5. Close your web browser.
Netgear WG602
The Netgear WG602 is an 802.11g Wireless Access Point. Its configuration can be
accessed with a web browser. First, open a web browser and connect to the access point
by entering the access point’s IP address in the location bar of your web browser. If you
do not know the IP address of the access point, please refer to the software or manual that
came with the access po int in order to determine the IP address. After successfully
logging in, you will see a page similar to the following:
accessed with a web browser. First, open a web browser and connect to the access point
by entering the access point’s IP address in the location bar of your web browser. If you
do not know the IP address of the access point, please refer to the software or manual that
came with the access po int in order to determine the IP address. After successfully
logging in, you will see a page similar to the following:
The value of “Wireless Network Name (SSID)” is the SSID that you will enter into the
SoundBridge’s wireless setup. Next, click on “Security Settings” on the left side to access
the WEP settings:
SoundBridge’s wireless setup. Next, click on “Security Settings” on the left side to access
the WEP settings: