Hitachi Kokusai Electric Inc. SL24G-US-02 Manuel D’Utilisation
3. Installation/Connection/Setup
3-5
Installing
35
(6) Attach the metal mounting bracket
1
When you have finished adjusting the angle
of orientation, mount on the mounting pole.
of orientation, mount on the mounting pole.
Firmly tighten the M6 bolts so that there is
no slippage in the antenna direction.
Firmly tighten the bolts giving consideration
to the shape and curvature of the pole.
Tighten to secure
2
When you have finished adjusting the angle
of elevation, tighten the four M6 bolts and
fix the angle of elevation for the metal
mounting bracket.
of elevation, tighten the four M6 bolts and
fix the angle of elevation for the metal
mounting bracket.
The torque for tightening the M6 nuts is
2.36 to 2.74 [N
m]
(24 to 28 [kgf
cm]).
Tighten to secure
3
If you have used a monitor cable, remove the
monitor cable from the main unit and cover by
tightening the M4 hexagon socket bolts.
monitor cable from the main unit and cover by
tightening the M4 hexagon socket bolts.
The torque for tightening the M4 hexagon
socket bolts is 0.89 to 1.07 [N
m] (9.0 to
11.0 [kgf
cm]).
Before covering, check closely to make
sure that there is no water or foreign
particles inside.
Tighten to secure
4
Wrap self-fusing tape over the drip-proof
cap on the LAN cable connector on the
main unit and then wrap vinyl tape on top of
that.
Use about one meter of each tape.
cap on the LAN cable connector on the
main unit and then wrap vinyl tape on top of
that.
Use about one meter of each tape.
Wrap up to the LAN
cable
cable
Section wrapped and
covered in self-fusing
tape and vinyl tape
covered in self-fusing
tape and vinyl tape
Tightly cover the drip-proof cap and
main unit connector with both tapes
main unit connector with both tapes
M
a
in
u
n
it
5
Connect the grounding wire with an M5 bolt.
Connect a grounding wire to the earth
terminal (FG).
Connect a grounding wire to the earth
terminal (FG).
Earth
terminal