Eastern Times Technology Co. Ltd DS-2605 Manuel D’Utilisation

 

2.4G wireless connection, operating range 10 meters 

PAW3212 sensor, low power and stable performance 

5 switchable CPI 800/1200/1600/2000/2400    

IR light tracing technology, work with many of surface 

Energy saving design with low power indicator and power switch on mouse body 

Plug & play Nano receiving adapter   

Before use: 

1.  Find the wireless mouse and Nano receiver in package 

2.  Plug Nano receiver to USB port on PC 

3.  Switch the button at the bottom of mouse body, battery cover can be open (check the 

pictures), Install 1PCS AA battery into Mouse body Properly 

4.  Put on power switch at the bottom of Mouse, LED indicator will keep flash for few 

second, the Mouse is ready to work.     

 

1.  CPI adjustable function 

With 5 adjustable CPI 800/1200/1600/2000/2400, factory setting is 1200CPI, Press 

and hold the left and right button and hold it for 3 seconds can be convert the 5 level 

CPI. 

Remark: Only AA battery is available 

2. Saving power mode and power switch off   

If mouse is stay out of work for 8 minutes, it will turn to power saving mode, press any 

button to restart it.   

If you turn off PC or take out Nano receiver from USB port, press any button or move the 

mouse to enter the power saving mode. 

3, Nano receiver   

A very small size design for Nano receiver, it can be plug and stay on USB port of 

PC/Notebook without interference. 

Portable design for travel, Nano receiver can be plug into the slot next to the battery 

position. 

  Both of mouse and Nano receiver has a built-in code, It can be setting one mouse to 

one receiver, or few of mouse to one receiver. Mouse and receiver need to reconnect 

under the condition of High temperature, high magnetic, strong vibrate. 

1.  Plug off the Nano receiver from USB port, and plug it on 

2.  Move RF mouse within 50CM to Nano receiver, re-install the battery, Press any key 

to reconnect, the above operation must be completed in 15 seconds. 

3.  Mouse will ready to work after reconnection.