Outsite Networks Inc. APX-2012 Manuel D’Utilisation

AllPoints Keypad Installation Manual  

Page 8 

 

To physically connect the AP Keypad printer to the LAN, use the Ethernet port on the 
back of the AP Keypad printer to connect it to the LAN. 
 

 
The AllPoints Keypad printer uses thermal paper.  The paper specifications are provided 
in Appendix C.  A roll of paper is provided in the box with every AP Keypad unit.   
 
Open the paper compartment by pressing down on the compartment latch button located 
on the left side of the paper compartment door.  
 
Insert the paper roll with the paper feeding over the top of the roll.  
 
Note:  There is an illustration on the inside of the paper compartment door showing 
how the paper should be loaded. 
 

 
The AP Keypad unit does not require a dedicated/isolated ground outlet.  However, the 
electrical service should be suitable for the installation of computer based electronic 
equipment. 
 
The AllPoints Keypad unit consists of two major components; the printer and the 
electronics base.   
 
Therefore powering on the AP Keypad unit is a two-step process:   
 

1.  Connect the provided AP Keypad power supply to the AP Keypad Power port on 

the back connection panel of the unit. 

2.  Connect the AP Keypad power supply to the electrical outlet.  
 

Note:  There is no power switch on an AllPoints Printer. Cycling power on the AP 
Keypad Unit requires disconnecting power at the power supply or outlet. 

 
The AP Keypad has several configuration items which may require setting.  Setting these 
item values maybe accomplished using one of two methods.