Mitel Deutschland GmbH 68635RFP36U-01 Manuel D’Utilisation
SIP-DECT OM System Manual
86
Searching
The RFP has lost synchronization to its neighbors. No DECT communication is possible. This phase
should usually last only for a few seconds after starting up the RFP or the OMM. If this state lasts longer
or is re-entered after being in a synchronous state this is an indication for a bad location of the RFP.
should usually last only for a few seconds after starting up the RFP or the OMM. If this state lasts longer
or is re-entered after being in a synchronous state this is an indication for a bad location of the RFP.
Inactive
The RFP has connected to the OMM but the air interface has not been switched on yet. For any RFP
with activated DECT functionality this phase should last only for a few seconds after starting up the RFP.
If this state lasts longer this may indicate a hardware failure.
with activated DECT functionality this phase should last only for a few seconds after starting up the RFP.
If this state lasts longer this may indicate a hardware failure.
Not connected
The RFP was configured but has not connected to the OMM yet. Therefore the IP address column is
empty.
empty.
Software Update available
The RFP is connected to the OMM. The OMM has found new software on the TFTP server. The RFP is
waiting for the OMM to initiate a reboot. In the meantime is the RFP fully operational.
waiting for the OMM to initiate a reboot. In the meantime is the RFP fully operational.
5.6.2 OMM / RFP SOFTWARE VERSION CHECK
When the DECT base stations connect to the OMM, they submit their software version. If this version
differs from the OMM software version and the versions are incompatible, the RFP connection attempt is
rejected. This could happen when using several TFTP servers with different OpenMobility software
versions. In this case, the RFP is marked with an error message. Moreover a global error message is
displayed on the RFP list web page if at least one version mismatch has been found.
differs from the OMM software version and the versions are incompatible, the RFP connection attempt is
rejected. This could happen when using several TFTP servers with different OpenMobility software
versions. In this case, the RFP is marked with an error message. Moreover a global error message is
displayed on the RFP list web page if at least one version mismatch has been found.
5.6.3 CREATING AND CHANGING BASE STATIONS
1 To configure a new RFP, click the New button on the Base Stations page.
To change the configuration of an existing RFP click on the
icon left beside the base station entry.
The
New base station (or the Configure base station) dialog opens.