MG International 040 Manuel D’Utilisation
Installation and operation guide - 15
f)
Lay and keep a magnet (for about 3 seconds) on the Swim Alert
TM
swimmer symbol, until you hear a short
loud beep and the Swim Alert
TM
red indicator light starts flashing quickly. The remote siren must emit a
beep.
g)
Return to the remote siren and press again with a pen on the black button on the side of your remote siren; a
sound signal is heard. Swim Alert
sound signal is heard. Swim Alert
TM
and your remote siren should now be synchronized.
h)
Move the magnet over the Swim Alert
TM
swimmer symbol: Swim Alert
TM
and the remote siren should each
emit a sound signal.
i)
Perform a fall test in your pool to validate the radio link. Turn the two sirens off by moving the magnet over
the swimmer symbol.
the swimmer symbol.
o
You can synchronize one or more Swim Alert
TM
with one or more sirens. To do this, you must repeat
operations d) e) f) and g) for each Swim Alert
TM
after having pressed the black button on the remote
siren(s).
o
You can re-initialize your remote siren by pressing the black button for a longer time (about 3 seconds).
You will then have to repeat the synchronization operations.
You will then have to repeat the synchronization operations.
-
Fixation
o
At the selected and validated location, drill two holes with a diameter of 0.25 in. one above the other, 3.5
in. apart. To make the radio link easier, it is recommended to position the siren as high as possible on the
wall (but check the length of the adapter cord) (Pict. 22)
in. apart. To make the radio link easier, it is recommended to position the siren as high as possible on the
wall (but check the length of the adapter cord) (Pict. 22)
o
Insert the two rawplugs into the two holes (Pict. 23)
o
Screw the two screws through the siren and into the rawplugs (Pict. 24)
Pict. 22
Pict. 23
Pict. 24