TECHCity Technology Co. Ltd. RP-20F Manuel D’Utilisation

e2-Live Home Automation

Edit by Amos /20150810

According to the following steps, you could insert one action into scenario edit setting program

planned well your action conditions, press

to add in this edit setting row

Click this edit setting row, use

to move this edit setting row to where you want be placed

Save

Single scenario storage, only saving the

current scenario of the screen

All scenario storage, saving all of the scenarios from No.1 ~ No.24 will take a little bit

longer, please make sure it was completed saved after red LED slow flash is stop.

During storage, the screen will be temporarily unable to carry out any operation action,

please do not remove the USB link cable, so as not to affect the action of storage.

operation with iPower

1. Plugs appliances into iPower, such as TV, DVD,CD

2. Use RP-20 to setting the location of remote control (refer to p4)

3. Fine tune every detection of home appliancesons on ipower to make sure correct detection

(please refer to iPower menu)

4. Use RP-20 software / scenario edit / power current detection defined

Content of scenario edit

(must to open TV)

Still power ON：During perform scenario, RP-20 will check the power current status of TV

If the TV is in the status of power ON, then RP-20 do not send out

the

command action. (to avoid reverse action)

If the TV is in the status of Power OFF, then RP-20 will send out the

command action to

turn on TV

Note: Please make sure the main power of iPower is in the status of Power ON, You

can recognized the current status of appliances powerby iPower

Still power OFF：If TV is in the status of power off, then RP-20 do not send out the

command action (to avoid IR reverse action)