OvisLink Corp. AIRMAX2 Manuel D’Utilisation
8. Bandwidth Control
69
AirLive AIRMAX2 User’s Manual
3. Enable the IP Control
4. If you have defined a Policy already, please choose a Policy name. The “Out Rates”
will be automatically pasted from the Policy template. You cannot change the Out
Rates if you have chosen a Policy
5. If you want to define new Data Rate, please do not choose any policies. Then you
can enter the values in the “LAN”, “WLAN”, or “WAN” Out Rates.
6. Press “Save” to save settings
7. Reboot
your
AP.
* If you want to control the traffic flow between the IPs in the same interface, please make
sure both IPs are configured for the IP Bandwidth Control.
8.4.4 Control by MAC Address
You can set the maximum bandwidth of a PC or a subscriber by using the MAC Control.
Please follow the procedure below to setup MAC Bandwidth Control:
1. Please make sure the “Interface Bandwidth Control” is disabled
2. Before you start, please check the following area to see which client MACs are
supported. It differs between each mode.
3. Enable the MAC Control
Please check this part to find out what IP addresses
are supported. It varies between each mode
are supported. It varies between each mode