CyberPower RMCARD202 Manuel D’Utilisation

 

 

 PowerPanel™ Business Edition 

 

 

 

 

 

 

 

 

 

 

 

       30    

„  None: The UPS has never performed the battery test.  

„  Failed: The battery test resulted in failure.  

Follow the below steps if the battery test fails:  

z  Repeat the battery test and replace the batteries if the test fails again.  

z 

Contact CyberPower for assistance if the battery test fails after the batteries have been replaced. 

 

The Runtime Calibration ensures the runtime estimate is accurate with the current load. The results show 

the runtime, the result, and the date of the last calibration. When a runtime calibration is initiated, the 

connected equipment will be run on battery power until the batteries are completely discharged. The 

batteries will be then automatically recharged following the calibration.  

Users can click the Start button to initiate a runtime calibration. Click the Cancel button to interrupt the 

runtime calibration. The result will be reported after a calibration is finished or canceled:  

z  Estimated Runtime: The estimated runtime of the batteries.  

z  Last Calibration Result: The result of the last runtime calibration.  

„  Passed: The runtime calibration completed and the batteries are good.  

„  None: The UPS has never performed a runtime calibration. 

„  Failed: The UPS failed during the runtime calibration.  

„  Canceled: The calibration was interrupted.  

z  Last Calibration Date: The date the last runtime calibration was performed.  

The Alarm Test allows users to verify the alarm can beep normally and show the date of the last test. Click 

Initiate button to begin an alarm test.  

The detail will be reported after an alarm test is complete: 

z  Last Processing Date: The date the last alarm test was performed.   

Indicators on the front panel or on the LCD screen are used to present the UPS status. Once the indicators 

are malfunctioned, users can’t know the current UPS status. The Indicator Test allows users to ensure 

whether indicators sparkle normally. Click Initiate button to begin an indicator test.