Xeline Co. LTd. MM-202BX Manuel D’Utilisation

MM-202BX

Installation Manual

This document is subject to change without prior notice.

4.4 Connecting the MM-202BX to the ISP Backbone

Note: To connect multiple MM-202BX units and the EU-200BX EMS unit, it is recommended to

prepare a Switch Hub in advance for installation.

①

Check the connection between the backbone and Switch Hub.

②

Connect the UPLINK port of the MM-202BX to the Switch Hub using the RJ-45 cable.

Figure 6 Connecting the MM-202BX to the ISP backbone

③

Once the MM-202BX is connected to the backbone, turn on the power of the MM-

202BX.

④

Wait approximately 3 minutes for the EU-200BX to finish the remote registration

process.

4.5 Checking the Final Connections

Note: When using the SU-200BX test unit, make sure it is set to Factory Default mode.

4.5.1 Checking the Ethernet connection

①

Connect the laptop PC to the LAN port of the MM-202BX using a RJ-45 cable.

②

Configure the network properties of the laptop PC as provided by the ISP.

③

Confirm if the Internet connection is working properly.

4.5.2 Checking the PLC connection using the SU-200BX test unit

①

Turn off the power of the MM-202BX.

②

Disconnect ALL cables (including the RJ-11 cable) from the MM-202BX except for the

Please refer to the SU-200BX Installation Guide for details on resetting to Factory Default

mode. The ACT LED of the SU-200BX will blink when successfully changed to the factory
default mode.

MM-202BX