TopSeed Technology Corp. TSEE-2401 Manuel D’Utilisation

(If you are reprogramming for the purpose of avoiding conflicts, skip to the next section 

since you will first want to erase all ID codes and channels)

With the USB receiver plugged into the powered on computer, take a narrow  

instrument, such as the uncurled end of a paperclip, and push and hold the reprogram  

button on the USB receiver until the LED indicator on the receiver (not the LED  

illumination light on the remote control) flashes two times.

Then quickly release the button within 1.5 seconds. 

Next, push the up button or down button on the remote control several times so that 

the USB receiver can receive signals from the remote control.

If the LED on the receiver flashes when you send signals, this indicates that the  

receiver has learned the new ID code and channel. It will still respond to its original 

and any previously added ID codes and channels as well (as long as you have not 

erased them per the procedure described further below).

Note: the receiver will abandon the process of adding a new ID code and channel if you 

wait more than 15 seconds to send a signal from the remote control or if you unplug 

the receiver. Also, since the receiver will not add the ID code and channel of a remote 

control it already is actively programmed to recognize, if you send a signal from your 

currently recognized remote control(s), the LED on the receiver will not accept it and 

will not flash during this 15 second reprogramming period.

You can repeat this procedure up to seven times for a total of eight learned ID codes 

and channels that will operate simultaneously. If you try to add more than seven  

additional ID codes and channels, the LED will flash but no ID code and channel will  

be added.