u-blox Malmo AB 000501 Manuel D’Utilisation
13
Chapter 5
Mounting
5.1 Instructions
The module cannot be mounted arbitrary, because off the radio communication. The
antenna of the module cannot be mounted in a metal enclosure. If a metal enclosure
is required, the Stub antenna (see 1/4
antenna of the module cannot be mounted in a metal enclosure. If a metal enclosure
is required, the Stub antenna (see 1/4
λ
stub antenna) could be mounted through a
panel hole or the coaxial antenna could be mounted outside the enclosure via the
coaxial cable (see Coaxial cable antenna).
coaxial cable (see Coaxial cable antenna).
The antenna should NOT to be mounted with
a distance of multiple half wavelengths (6cm)
from a conductive surface.
a distance of multiple half wavelengths (6cm)
from a conductive surface.
Figure 1 - Antenna placement
The minimum distance between the user application printed circuit board and the
OEM-Bluetooth module is 3mm (0.118”)
OEM-Bluetooth module is 3mm (0.118”)
≠
n
⋅λ
/2 = 0, 6, 12 cm
A cubic space with 1”side around the SMD antenna
must be free from wires, circuits or other conductive
components of the user application.
must be free from wires, circuits or other conductive
components of the user application.
Illustration of user application
OEM Bluetooth module
0005-01
0005-01