Wilson Electronics LLC 2B1225 Manuel D’Utilisation

Ensure that both the outside antenna coax cable and the adapter coax cable are con-

1 . 

nected to the signal booster before powering up the signal booster .

Connect the power supply to the power input labeled with the USB symbol on the 

2 . 

signal booster . Plug the power supply into a wall outlet .

The indicator light on the top of the signal booster will be GREEN when the unit is pow-

3 . 

ered up and working properly .

If the light is off, ensure power supply connections are tight .

4 . 

Carefully insert the 

power cable .

Warning: Use only a Wilson Electronics 

power supply . Use of a non-Wilson 

Electronics product could damage your 

equipment .

Warning: Verify that both the outside 

antenna and the adapter extension cable 

are connected to the signal booster before 

powering up the signal booster .

To test your signal booster, go to a weak signal area where your cell phone registers only 

1-2 bars without the signal booster turned on .  Then, connect the signal booster to the 

phone and you should see a signal improvement of 2 or more bars . 

Installing the Mounting Plate on DataPro™ Signal Booster (optional)

To purchase a mounting plate call Wilson Electronics Sales Team 800-204-4104 .

Remove  two  screws  from  back  of 

signal booster that correspond with the 

mounting plate .

Place signal booster on mounting plate 

and reinstall the two screws previously 

removed from back of signal booster .
Caution: Do not remove “Void Sticker.”