Netgear 05200007 Manuel D’Utilisation

Configuring L2TP Connections

4-5

1.

In the Security Policy Editor, in the Network Security Policy list, click the specific secure 
connection .

2.

In the Remote Party Identity and Addressing group, configure the remote party's information. 

Note: When configuring security for L2TP, the remote party is the L2TP network server 
(LNS).

a.

In the ID Type box at the top of the group, click one of these remote party identifiers: 

•

Domain name

•

IP address

•

Email address

•

Distinguished name

•

Any

b.

In the IP Address box, type the IP address of the LNS.

c.

In the Protocol box, click UDP.

d.

In the Port box, click L2TP. 

e.

Unless otherwise instructed, make sure that the Connect using check box is clear.

3.

Ask the remote party if you need to change the Port value to L2TP in My Identity. 

4.

When you configure the Key Exchange (Phase 2) proposal, in the Encapsulation box, click 
Transport, which is the typical L2TP connection setting.

5.

Click Save.

Note: If you use a network or broadband connection, such as cable or DSL, to establish an L2TP 
connection on a network, skip this topic; it doesn't apply. If you have questions, contact your 
network security administrator.

If you establish the L2TP connection from your computer through a physical dial-up connection—
that is, a modem—your computer requires two Microsoft dial-up connections or adapters: 

•

One for the L2TP connection, which is a virtual connection