Netgear 10300137 Manuel D’Utilisation

implemented on the router.

Adding Wireless Computers that Do Not Support WPS

If you set up your network with WPS, and now you want to add a computer that does not 
support WPS, you must manually configure that computer. To view the wireless settings for 
the router, see “Manually Configuring Your Wireless Settings” on page

Because WPA randomly creates the SSID and WPA/WPA2 keys, they might be difficult to 
type or remember (that is one reason why the network is so secure). You can change the 
wireless settings so that they are easier for you to remember. If you do that, then you will 
need to set up the WPS-compatible computers again.

Making these changes will cause all wireless computers to be 

disconnected from network. You will then have to set them up with 
the new wireless settings.

Use an Ethernet cable to connect a computer to the router. That way you will not get 
disconnected when you change the wireless settings.

Make the following changes:

Change the Wireless Network Name (SSID) to a meaningful name.

On the WPA/PSK + WPA2/PSK screen, select a passphrase.

Make sure that the Keep Wireless Settings checkbox is selected in the WPS Settings 

screen so that your new settings will not be erased if you use WPS.

Click Apply so that your changes take effect. Write down your settings.

All existing wireless clients are disassociated and disconnected from the router.

For the non-WPS devices that you want to connect, open the networking utility and follow 
the utility’s instructions to enter the security settings that you selected in Step 2 (the SSID, 
WPA/PSK + WPA2/PSK security method, and passphrase).

For the WPS devices that you want to connect, follow the procedure “WPS Button” on 
page

The settings that you configured in Step 2 are broadcast to the WPS devices so that they 
can connect to the router.