Netgear 10300137 Manuel D’Utilisation
54
|
Chapter 5: Advanced
Mobile Broadband 11n Wireless Router MBR1000
applications that may not function well. In some cases, one local computer can run the
application properly if that computer’s IP address is entered as the default DMZ server.
application properly if that computer’s IP address is entered as the default DMZ server.
Incoming traffic from the Internet is normally discarded by the router unless the traffic is a
response to one of your local computers or a service that you have configured in the Ports
screen. Instead of discarding this traffic, you can have it forwarded to one computer on your
network. This computer is called the default DMZ server.
response to one of your local computers or a service that you have configured in the Ports
screen. Instead of discarding this traffic, you can have it forwarded to one computer on your
network. This computer is called the default DMZ server.
To assign a computer or server to be a default DMZ server:
1.
Go to the WAN Setup screen as described in the previous section.
2.
Select the Default DMZ Server check box.
3.
Type the IP address for that server.
4.
Click Apply to save your changes.
LAN IP Settings
The LAN IP Setup screen allows configuration of LAN IP services such as DHCP and RIP.
These features can be found under the Advanced heading in the router main menu.
These features can be found under the Advanced heading in the router main menu.
The router is shipped preconfigured to use private IP addresses on the LAN side, and to act
as a DHCP server. The router default LAN IP configuration is:
as a DHCP server. The router default LAN IP configuration is:
•
LAN IP addresses: 192.168.0.1
•
Subnet mask: 255.255.255.0
These addresses are part of the Internet Engineering Task Force (IETF)-designated private
address range for use in private networks, and should be suitable in most applications. If your
network has a requirement to use a different IP addressing scheme, you can make those
changes in this screen.
address range for use in private networks, and should be suitable in most applications. If your
network has a requirement to use a different IP addressing scheme, you can make those
changes in this screen.
To view or change the LAN IP Setup:
Tip:
If you change the LAN IP address of the router while connected through
the browser, you will be disconnected and so will others connected to the
router. To connect to the router, you must open a new connection to the
new IP address and log in again. Others using the router must restart
their computers to connect to the router again.
router. To connect to the router, you must open a new connection to the
new IP address and log in again. Others using the router must restart
their computers to connect to the router again.