Netgear 10300137 Manuel D’Utilisation

Configure the operating mode of the routers.

Because it is in a central location, configure the MBR1000 router (AP 1) on LAN 

Segment 1 in Point-to-Multi-Point Bridge mode and enter the MAC addresses of AP 2 
and AP 3 in the Remote MAC Address 1 and Remote MAC Address 2 fields.

Configure the access point (AP2) on LAN Segment 2 in Point-to-Point Bridge mode 

with the remote MAC address of the MBR1000 router.

Configure the access point (AP3) on LAN Segment 3 in Point-to-Point Bridge mode 

with the remote MAC address of the MBR1000 router.

Disable the DHCP server on AP2 and AP3. AP1 will then be the DHCP server.

Verify the following for all access points:

The LAN network configuration of the router and other access points are configured to 

operate in the same LAN network address range as the LAN devices.

Only one access point, the MBR1000 router, is configured in Point-to-Multi-Point 

Bridge mode; all the others are in Point-to-Point Bridge mode.

All access points, including the MBR1000 router, must be on the same LAN. That is, 

all the access point LAN IP addresses must be in the same network.

All access points, including the MBR1000 router, must use the same SSID, channel, 

authentication mode, if any, and encryption in use.

All point-to-point access points must have the MAC address of AP 1 (the MBR1000 

router in the above diagram) in the Remote AP MAC address field.

Verify connectivity across the LANs. 

A computer on any LAN segment should be able to connect to the Internet or share 

files and printers with any other PCs or servers connected to any of the three LAN 
segments.

Wireless stations configured as they are in the previous example will 

not be able to connect to the router or access points. If you require 
wireless stations to access any LAN segment, you can use 
additional access points configured in Wireless Access Point mode 
in any LAN segment.

Repeater with Wireless Client Association

In this mode, the Mobile Broadband 11n Wireless Router sends all traffic to a remote AP. For 
Repeater mode, you must enter the MAC address of the remote “parent” access point. 
Alternatively, you can configure the Mobile Broadband 11n Wireless Router as the parent by 
entering the address of a “child” access point. Note that the following restrictions apply:

You cannot disable client associations with this Mobile Broadband 11n Wireless Router.