Netgear WGR614v3 Manuel D’Utilisation

Preparing Your Network

C-1

This appendix describes how to prepare your network to connect to the Internet through the Model 
WGR614 Cable/DSL Wireless Router and how to verify the readiness of broadband Internet 
service from an Internet service provider (ISP).

Computers access the Internet using a protocol called TCP/IP (Transmission Control Protocol/
Internet Protocol). Each computer on your network must have TCP/IP installed and selected as its 
networking protocol. If a Network Interface Card (NIC) is already installed in your PC, then TCP/
IP is probably already installed as well.

Most operating systems include the software components you need for networking with TCP/IP:

•

Windows

®

 95 or later includes the software components for establishing a TCP/IP network. 

•

Windows 3.1 does not include a TCP/IP component. You need to purchase a third-party TCP/
IP application package such as NetManage Chameleon.

•

Macintosh Operating System 7 or later includes the software components for establishing a 
TCP/IP network.

•

All versions of UNIX or Linux include TCP/IP components. Follow the instructions provided 
with your operating system or networking software to install TCP/IP on your computer.

If an ISP technician configured your computer during the installation of a 

broadband modem, or if you configured it using instructions provided by your ISP, you 
may need to copy the current configuration information for use in the configuration of 
your firewall. Write down this information before reconfiguring your computers. Refer 
to 

” on 

 or 

further information.