Netgear WGR614v3 Manuel D’Utilisation

3-6

Wireless Configuration

•

Disable. No encryption will be applied. This setting is useful for troubleshooting your wireless 
connection, but leaves your wireless data fully exposed.

•

64-bit or 128-bit WEP. When 64-bit or 128-bit is selected, WEP encryption will be applied. 

If WEP is enabled, you can manually or automatically program the four data encryption keys. 
These values must be identical on all PCs and access points in your network.

There are two methods for creating WEP encryption keys:

•

Passphrase. Enter a word or group of printable characters in the Passphrase box and click the 
Generate button. These characters are case sensitive.

•

Manual. For 64-bit WEP, enter 10 hexadecimal digits (any combination of 0-9, a-f, or A-F). 
For 128-bit WEP, enter 26 hexadecimal digits (any combination of 0-9, a-f, or A-F). These 
values are not case sensitive.

When you first receive your WGR614, the default factory settings are shown below. You can 
restore these defaults with the Factory Default Restore button on the rear panel. After you install 
the WGR614 router, use the procedures below to customize any of the settings to better meet your 
networking needs.

Wireless Access Point

Wireless Access List (MAC Filtering)

SSID broadcast 

SSID 

11b/g RF Channel

Mode

Authentication Type

WEP