Microsoft Corporation HS3W Manuel D’Utilisation
G e t t i n g s t a r t e d
7
■ Chargers and batteries
Check the model number of any charger before using it with this device. The
Wireless Clip-on Headset HS-3W is intended for use with the following chargers:
ACP-7, ACP-8, ACP-9, ACP-12, and LCH-12
Wireless Clip-on Headset HS-3W is intended for use with the following chargers:
ACP-7, ACP-8, ACP-9, ACP-12, and LCH-12
Warning! Use only batteries and chargers approved by Nokia for use
with this particular enhancement. The use of any other types will
invalidate any approval or warranty applying to the enhancement, and
may be dangerous.
with this particular enhancement. The use of any other types will
invalidate any approval or warranty applying to the enhancement, and
may be dangerous.
For availability of approved batteries and chargers, please check with your local
dealer.
dealer.
When you disconnect the power cord of any enhancement, grasp and pull the
plug, not the cord.
plug, not the cord.
■ Removing and installing the battery
Note: Before changing the cover, always switch off the power and
disconnect the device from the charger. Always store and use the
device with the covers attached.
disconnect the device from the charger. Always store and use the
device with the covers attached.
The headset has a rechargeable LiPo battery.
• Open the battery cover by gently pushing the release button and
sliding the battery cover backwards, see Figure 2.1.
• Remove the battery, see Figure 2.2.
• Detach the connector from its space and detach the battery from the
connector, see Figure 2.3.
• Replace the battery. Place the connector in the space reserved for it
and set the battery in place, see Figure 2.4.
• Close the battery cover, see Figure 2.5.
• Make sure that the cover is properly locked in place, see Figure 2.6.
■ Charging the battery
1. Connect the charger cable to the headset as shown in Figure 3.
2. Connect the charger to an AC wall outlet with an easy access. The
red indicator light is displayed during charging. Charging the battery
fully may take up to 2 hours 45 minutes depending on the charger.
fully may take up to 2 hours 45 minutes depending on the charger.
hs-3W_en1TA.fm Page 7 Thursday, June 26, 2003 2:47 PM