Digital Antenna DA4000N Manuel D’Utilisation

phone (954) 747-7022    fax (954) 747-7088   www.DigitalAntenna.com

5325 N.W. 108

th  Avenue,  Sunrise, FL  33351

ll

Cell amplifier installation instructions.

1) Place the amplifier in a suitable location in the instrument console and plug the 
power cord into the cigarette socket or appropriate power jack.  If hard wiring to a 
power block, be certain that the positive lead connects to the center pin of the 
amplifier power connector.

    

Caution:
The antenna(s) used for this transmitter must not be co-located or operating in 
conjunction with any other antenna or transmitter. Failure to observe the following 
restri ctions will result in exceeding the FCC RF exposure limits.

    

Antennas used for this transmitter must not exceed an antenna gain of 3 dBi with a 
minimum cable loss of 2.9 dB.  For rear deck trunk and roof top installations, the 
antenna must be located at least 20 cm away from rear-seat passengers and 
bystanders in order to comply with the FCC RF exposure requirements.

    

Antennas used for this transmitter must not exceed an antenna gain of 7 dBi with 
minimum cable loss of 5.4 dB.  The antenna m

ust be located at least 20 cm away 

from passengers in order to comply with the FCC RF exposure requirements.

3) Connect one end of the cell phone adapter cable to the amplifier were it is 
marked "phone" and the other end to the cell phones antenna port.

4) After you are certain that all connections are tight and secure, move the switch 
labeled "on/off" to the on position.  A green light will illuminate indicating that the 
amplifier is ready for use.

2)"FCCRFExposureRequirements"

(a)Vehicle-AntennaInstallation:

(b)Boat-AntennaInstallation:

: 

NOTE

It is normal for the amplifier to be warm during operation.

This equipment has been tested and found to comply with the limits for a class B 
device, pursuant to Part 15 and the Specialized Mobile Radio Service authorized 
under  subpart H of part 22 and part 90 of the FCC rules.  These limits are 
designed to provide reasonable protection against harmful interference. This 
equipment generates, uses and can radiate radio frequency energy and, if not 
installed and used in accordance with this instruction manual, may cause harmful 
interference to radio commun

ications,  However there is no guarantee that 

interference will not occur in a particular installation.  If this equipment does cause 
harmful interference to radio or other electronic reception, which can be 
determined by turning the equipment off and on, the user is encouraged to try to 
correct the interference by one of more of the following measures:

Reorient or relocate the receiving antenna
Increasetheseparationbetweentheequipmentandreceiver
Connecttoisolatedpowerwithagroundcablegoingdirectlyt

othebatteryor

DCsource
Repositioningofthecoaxialcablemayalsoeliminateinterference.    
ConsultthedealeroranexperienceElectronicstechnicianforhelp.

:ChangesormodificationsnotexpresslyapprovedbyDigitalAntenna,

Inc.couldvoidtheuser'sauthoritytooperatetheequipment.

l
l
l

l
l

Donotcoil

Warning

Model #DA4000N
Cellular Amplifier