Maxon Electronics Australia Pty. Ltd. MM-5100 Manuel D’Utilisation
MM-5100 Hardware – User Manual
Jan. 22, 2003
18 of 18
4. Appendix
A
Software downloading (updating) method
Perform according to the procedure listed below.
Downloading procedure of Firmware is as follows;
1) Disconnect the power cable from MM-5100 Wireless Modem
2) Connect Ear-piece
3) Connect RS232 cable
4) Open “Maxon Firmware Update Program” which is a software downloading program
5) Connect the power cable to MM-5100 Wireless Modem
6) Check that Firmware Update program is operating normally.
If Firmware update is finished, the MM-5100 Wireless Modem will initialize itself and will be
ready to commence its service function.
(Note 1) Power supply and data cable must remain connected while the firmware is downloading.
(Note 2) Please refer to the “Maxon Firmware Update program” manual for detailed information.
If you click “Update” on Firmware Update Program, the message below will be displayed.
1. Please Reset Modem
2.
Wait for response from modem