AeroScout FM Manuel D’Utilisation

 

M310 Fall Monitor – Setup & User Guide iii

•  A low battery condition in the Monitor is indicated by the Low Battery 

indicator flashing YELLOW once every 3 seconds. Immediately change 
the monitor’s batteries.

•  Test the M310 Fall Monitor and Sensormat pad before each use and 

inspect the cords and pads for signs of damage. Immediately replace 
any components with signs of wear or damage.

•  Sensormats may not be effective with air type bed mattresses or air 

type chair cushion pads; test before using.

•  Do not place the monitor within 1 ft. (0.3m) of and facing the resident. 

Placing the Monitor on a wheelchair back is acceptable as long as the 
monitor is facing away from the resident.

•  The M310 Fall Monitor is only one part of your facility’s fall 

management program. The M310 Fall Monitor is not a substitute for 
proper nursing care or routine visual monitoring by caregivers. The 
effectiveness of the M310 Fall Monitor relies entirely on an immediate 
response by the caregiver to the M310 Fall Monitor system alarm.

•  The M310 Fall Monitor system will not stop a person from leaving a 

bed or chair. It is intended only to alert a caregiver that a patient or 
resident may need assistance. Other interventions may be required.

•  Keep the Sensormat pad flat at all times. Folding the pad may damage 

it. Do not use the pad if it has been folded.

•  Do not immerse the Sensormat pads in liquids. The pad will not 

operate properly if the pad is exposed to excessive liquids. If the pad is 
immersed in liquid, discard it immediately.

•  Operators of this equipment must be familiar with the functions and 

usage as described in this manual, and must be properly trained in the 
resident care policies and procedures of the facility.

•  Any modification of this equipment is not allowed, voids all 

warranties, and may result in injury to or death of persons in your 
care.