CipherLab Co. Ltd. 1664 Manuel D’Utilisation

 

 

233

 

Update 

 

Upgrade firmware of one scanner at a time. For example, turn off each of the rest 

scanners when there is more than one scanner connected to host computer. 

Note:  1. In case it fails downloading due to low battery, make sure the targe scanner is        

loaded with good battery and the battery charge is enough.                             

2. In order to avoid the data losing during firmware upgrade. Please save or 
upload all the data from the flash memory before beginning firmware upgrade. 

HOW TO UPGRADE FIRMWARE 

USING 3610 

1)  Connect 3610 to the USB port of PC after installing its driver. 
2)  Refer to 

3.1.1 Connect to 3610

 the target scanner to connect to 3610. 

Read the “Set Connection” label first, and then the “Serial Number” label. Both labels 

can be located at the back of 3610.   

3)  Read the following barcodes in sequence to configure the scanner to use USB Virtual 

COM as download interface. 

 

 

 

 

 

 

 

Note:  For 1664, also choose to use “Direct” USB Virtual COM interface. 

4)  Read the following barcodes in sequence for the scanner to enter the download mode. 

The scanner will respond with beeps to indicate it is ready for downloading. 
 

Appendix I 

FIRMWARE UPGRADE