CipherLab Co. Ltd. 1664 Manuel D’Utilisation

243

Update

Appendix II

錯誤! 使用 [常用] 索引標籤將 Heading 1 套用到您想要在此處顯示的文字。

For the scanner to read the serial number and beep -

#@RDSN<CR>

#@////<CR>

Note: (1) For USB Virtual COM, only configure the first scanner that connects to 3610.

To identify the scanner, send the serial command to have it respond with a beep.
(2) For Bluetooth

SPP, allows configuring up to seven scanners at the same time.

3610 SETUP BARCODES & SERIAL COMMANDS

Normally, configure the 3610 dongle by having a connected scanner read 3610-related
setup barcodes.

1) Connect 3610 to the USB port of PC. 3610 needs to install its driver first!
2) Refer to

3.1.1 Connect to 3610

for the target scanner to connect to 3610.

Read the “Set Connection” label first, and then the “Serial Number” label. Both labels

can be located at the back of 3610.

3) Read the following barcodes in sequence to configure 3610.

Enter Setup

Update

For 3610-related setup barcodes, refer to the Serial Command table below. Note that for

the “Version” and “GetID” barcodes, it must run HyperTerminal.exe or any text editor to
receive the information.

If the output interface is USB Virtual COM, run HyperTerminal.exe on the host
computer to receive the information.

If the output interface is USB HID, run any text editor to receive the information.

(3610-related setup barcodes)