CipherLab Co. Ltd. 1664 Manuel D’Utilisation

28

 

Enter Setup 

1664 Barcode Scanner 

User Guide

 

 

Send Data 

When the memory is used up, the scanner will respond with two short beeps (high-low tone) as a 

warning. It is advised to send data to the host immediately by having the scanner read the “Send 

Data” barcode below.   
1664 can send data via “Direct USB” interface once the computer has found the USB connection. 
Refer to 

1.13 Using Direct USB Cable

. Because the time-out value is set to 0 by default, connect 

the cable before having the scanner read the “Send Data” barcode. Otherwise, the scanner will try 

to temporarily resume the previous WPAN connection with the host, if there is any. 
During data transmission upon memory mode, if the data is transmitted fail, the scanner will flash 
red (On/Off ratio 0.2 s: 0.2 s) after responding two short beeps (high-low tone) and go back to 

previous working mode. Press trigger or power key to stop flashing. 

Send Data Time-out 

if a time-out value other than zero is given, it will first try to send data via “Direct USB” interface 

within the specified period of time. Connect the cable before it times out. When the attempt fails, it 

will try to temporarily resume the previous WPAN connection with the host, if there is any.   
If 1664 has never been connected to the host cordless, it will not be able to send data until to 
connect the Direct USB cable! 

Clear Data & Confirm 

Even though data has been sent back to the host, the flash memory is still occupied unless you 

erase the memory by having the scanner read two barcodes – “Clear Data” and “Confirm”. 

1.  Read the “Clear Data” barcode to clear the flash memory. 

2.  Read the “Confirm” barcode to confirm the action.