CipherLab Co. Ltd. 3656CRADLE Manuel D’Utilisation
17
Update
錯誤
錯誤
錯誤
錯誤! ! ! ! 使用
使用
使用
使用 [[[[常用
常用
常用
常用] ] ] ] 索引標籤將
索引標籤將
索引標籤將
索引標籤將 Heading 1
Heading 1
Heading 1
Heading 1
套用到您想要在此處顯示的文字
套用到您想要在此處顯示的文字
套用到您想要在此處顯示的文字
套用到您想要在此處顯示的文字。
。
。
。
READ A SETUP
READ A SETUP
READ A SETUP
READ A SETUP BARCODE
BARCODE
BARCODE
BARCODE
CONFIGURE PARAMETERS
CONFIGURE PARAMETERS
CONFIGURE PARAMETERS
CONFIGURE PARAMETERS
For most of the scanner parameters, only one read is required to set them to new values.
The scanner will respond with two beeps (low-high tone) when each parameter is set
successfully.
The scanner will respond with two beeps (low-high tone) when each parameter is set
successfully.
But for a number of special parameters, multiple reads are required to complete the
setting. In this case, the scanner will respond with a short beep to indicate it needs to
read more setup barcodes. These special parameters may require reading one or more
setup barcodes, such as
setting. In this case, the scanner will respond with a short beep to indicate it needs to
read more setup barcodes. These special parameters may require reading one or more
setup barcodes, such as
Numeric barcodes, say, for keyboard type, inter-character delay, length qualification
Hexadecimal barcodes, say, for character strings as prefix, suffix, etc.
When “BT HID”, “USB HID” or “Keyboard Wedge” is configured for interface, Key
Type and Key Status will then become applicable. You may decide whether or not to
change key status when “Normal Key” is selected for Key Type.
Type and Key Status will then become applicable. You may decide whether or not to
change key status when “Normal Key” is selected for Key Type.
To complete the configuration of these special parameters, it requires reading the
“Validate” barcode, and the scanner will respond with two beeps (low-high tone) to
indicate the input values are validated.
“Validate” barcode, and the scanner will respond with two beeps (low-high tone) to
indicate the input values are validated.