Inside Secure M300 Manuel D’Utilisation
Page 9
PRE:
1: Increases pre-selection with INSIDE CONTACTLESS anti-collision and a large number of cards.
0: Standard anti-collision (best for 5 cards max.).
AUTH:
1: Performs a standard INSIDE authentication.
Authentication is performed if the key is set as the current key.
Please refer to appendix A : «How to low a key» for key loading and key management operations
details.
Please refer to appendix A : «How to low a key» for key loading and key management operations
details.
0: Does not perform an authentication.
KEY:
1: Authenticates with Debit Key (Kd = Key 1) if AUTH is set.
0: Authenticates with Credit Key (Kc = Key 2) if AUTH is set.
P2: Parameter used for selecting the card types to be read
B7-b4
B3
B2
B1
b0
0
Protocol 3
Protocol 2
Protocol 1
Protocol 0
INSIDE couplers manage the following protocols :
•
Protocol 0 : ISO 14 443 type B & Inside anticollision (only for INSIDE chip)
•
Protocol 1 : ISO 15 693 & Inside anticollision (only for INSIDE chip)
•
Protocol 2 : ISO 14 443 type B-3
•
Protocol 3 : User defined protocol - see «Other ISO chip management» chapter for more information
about Protocol 3 use.
about Protocol 3 use.
If bit related to protocol x is set to one, coupler will run an anticollision using this protocol.
If several protocols are selected, coupler will test all of them, starting from protocol 0 to protocol 3.
P3: Number of bytes to be return by the coupler
Set P3 = 09h for reading Pico Family Chips serial numbers.
Response: Card type (1 byte) and serial number (8 bytes)
Card type is the protocol number used by the card that has been selected for its answer.
For 15 693 INSIDE’s chips, card type value is 1 as protocol 1 is used for selection. This value is the one to use
to indicate protocol in the transmit command.
to indicate protocol in the transmit command.
Couplers - Reference Manuel V1.3