HydroPoint data systems inc. WT008 Manuel D’Utilisation
Set Program Mode
1.
1.
Turn the Upper Line dial until you see:
2.
Turn the Lower Line dial to select “Fully Automated” from the
following choices:
following choices:
•
Fully Automated (Default Setting)
•
User Programmed-With ET
•
User Programmed-NO ET
•
OFF
Note:
Each of the program modes is shown sequentially.
Set Schedule
1.
1.
Turn the Upper Line dial until you see:
2.
Turn the Lower Line dial to select one of the following choices:
•
A, or
•
B.
Use Water Window
1.
1.
Turn the Upper Line dial until you see:
This tells the controller whether this station should use the water
window you entered in “Setup”. The controller calculates the
end time.
window you entered in “Setup”. The controller calculates the
end time.
USE WATER WINDOW STA 01
Yes (end time 11:01pm)
SET SCHEDULE STA 01
A
–
SET PROGRAM MODE STA 01
Fully Automated
Programming Your WeatherTRAK ET Plus
35
12. Set Slope Factor
This refers to the relative flatness of your landscape.
•
Slope factors are aimed at reducing runoff and maximizing
water intake by the plants roots.
water intake by the plants roots.
•
Slope factors will impact the duration of each water cycle
and the number of cycles required to apply water.
and the number of cycles required to apply water.
•
The steeper the slope the greater the number of cycles and
the lower the run time per cycle.
the lower the run time per cycle.
13. Set Sprinkler Location
This is when the sprinklers are on a slope.
•
If the slope is “0”, you will not be allowed to select a
location because it’s not applicable.
location because it’s not applicable.
14. Set Usable Rainfall
This feature only works with the Rainfall Service.
All of these values are entered for each station. To speed up the
entry process, you can copy information from one station to
another and then edit as required.
entry process, you can copy information from one station to
another and then edit as required.
To Begin Fully Automated Programming:
Set Station to Program
1.
1.
Turn the Function Selector dial to “Program.”
You will see the following display:
2.
Turn the Lower Line dial to the desired station. You have the
following choices:
following choices:
•
STA 1, 2, 3, etc. up to the Maximum Active Station number
that you entered during “Setup.”
that you entered during “Setup.”
SET STA TO PROGRAM
Program STA 01
Programming Your WeatherTRAK ET Plus
34