ViVOtech Inc. VPS500A Manuel D’Utilisation
ViVOpay OEM S500 Technical Reference
Magnetic Stripe Card Reader Emulation
The Reader emulates a Magnetic Stripe Card Reader by sending the data read from a
card/tag out as Track 1 and Track 2 data using the –IT1D, –IT1CLK, –IT2D, –IT2CLK,
and –ICP signals located at J2 on the Control PCA. The output signals are TTL (+5V)
levels.
Data read from a card/tag is sent to the host only if valid Track 1 and/or Track 2 data
is present on the card. Track 1 data is sent using the –IT1D, –IT1CLK signals; Track 2
data is sent using the –IT2D and –IT2CLK signals. Data is valid for both Track 1 and
Track 2 when the –ICP signal is active.
The timing diagram below illustrates the timing used with Magnetic Card emulation.
The timing represents an average card swiping speed of 20 cm/s.
card/tag out as Track 1 and Track 2 data using the –IT1D, –IT1CLK, –IT2D, –IT2CLK,
and –ICP signals located at J2 on the Control PCA. The output signals are TTL (+5V)
levels.
Data read from a card/tag is sent to the host only if valid Track 1 and/or Track 2 data
is present on the card. Track 1 data is sent using the –IT1D, –IT1CLK signals; Track 2
data is sent using the –IT2D and –IT2CLK signals. Data is valid for both Track 1 and
Track 2 when the –ICP signal is active.
The timing diagram below illustrates the timing used with Magnetic Card emulation.
The timing represents an average card swiping speed of 20 cm/s.
t
0
0 0 0 0 0 1 1 1 0 0 1 1 0
720 usec.
480 usec.
‐ICP
‐ITD
‐ITCLK
Emulated Magnetic Card Reader Timing
Magnetic Strip Card Emulation
The Reader can also output Track 1 and Track 2 magnetic stripe F2F encoded data
which can be injected into the heads of a magnetic strip card reader and read by it.
Low power Track 1 and Track 2 analog data is output on the J2 Strip Drive signals
TRACK1 and TRACK2. High Power Strip Drive 9V differential signals are output on
TRACK2+ and TRACK2‐. Note that operation of the High Power Strip Drive signals
requires an additional 9VDC, 500ma. power input on J2 pin 4.
which can be injected into the heads of a magnetic strip card reader and read by it.
Low power Track 1 and Track 2 analog data is output on the J2 Strip Drive signals
TRACK1 and TRACK2. High Power Strip Drive 9V differential signals are output on
TRACK2+ and TRACK2‐. Note that operation of the High Power Strip Drive signals
requires an additional 9VDC, 500ma. power input on J2 pin 4.
Document: 740‐0005‐00 Rev. 1.0
8
Proprietary & Confidential