K&B International Ltd. 9309R Manuel D’Utilisation

 

 

THIS DEVICE COMPLIES WITH PART 15 OF THE FCC RULES. OPERATIONIS 
SUBJECT TO THE FOLLOWING TWO CONDITIONS: 
(1) THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE, AND 
(2) THIS DEVICE MUST ACCEPT ANY INTERFERENCE RECEIVED, 
INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED OPERATION. 

 

 

Product: Motion sensor with RF transmitter 
Frequency: 433.92MHz 
Power: 120V/60Hz 

The RF module can be operated with 100 feet in open field.

The unit can work in normal mode or in override mode.   

 

Three level sensitivity of PIR sensor can be selected: high/middle/low level sensitivity. 
In normal work mode, three kinds of lamping time can be selected: 30/60/180 
seconds. 
When power is on, the device will be in the case of initialization showed below: 

1.  Lamp is off 

 

2.  Time: green led is lighting 

 

3.  Time: red led is off 

 

4.  PIR Sensor green led is lighting 

 

5.  PIR Sensor red led is off 

 

6.  PIR Sensor’s sensitivity is in the low level 

 

7. 

Work in normal mode

 

 

This switch controls the sensitivity of the motion sensor range. Pushing the switch 

will change the status of sensitivity indicated by LED. Red means high, green means 
low and both on means middle

.  

 

 

This switch controls the length of time the light remains on after the final motion is 

detected. Pushing the switch will change the status of time indicated by LED. Red 
means 3 minute, green means 30 seconds and both on means 1 minute.

     

 

Turn off the wall switch and then on immediately within 2 seconds will turn the 

sensor into manual override status, which means the light will be turned on and 
remain on until the wall switch is turned off or until morning. Turn off the switch for 
at least 5 seconds and then on again will resume the sensor back to automatic status

.