Possio AB QEQU00065 Manuel D’Utilisation
5.5 Control Panel
17
5.5.5
AP IP Settings
This module is used for setting IP address and netmask for the Wireless LAN interface. If
you make changes to settings described in this section you will not be able to connect to
the PX30 in the same way as described in the "Getting started" section in this user’s guide.
you make changes to settings described in this section you will not be able to connect to
the PX30 in the same way as described in the "Getting started" section in this user’s guide.
IP
Set the IP of the Wireless LAN interface
Subnet mask
Subnet mask of the Wireless LAN interface
5.5.6
AP Wireless Settings
Module for setting wireless properties. If you make changes to settings described in this
section you will not be able to connect to the PX30 in the same way as described in the
"Getting started" section in this user’s guide.
section you will not be able to connect to the PX30 in the same way as described in the
"Getting started" section in this user’s guide.
ESSID:
The essid that should be used to connect to this device.
Encryption key:
The encryption key that should be used by the device. This should be
entered as a hex value (0-9, a-f), for weak encryption enter 10 digits,
for strong encryption enter 26 digits.
entered as a hex value (0-9, a-f), for weak encryption enter 10 digits,
for strong encryption enter 26 digits.
Channel:
The WLAN channel to use. This number should be between 1-13.
Ble LED blink:
Turns on and off the Blue LED WLAN traffic indication.